Evaluation of the addition of wheat residues in the production of Pinus oocarpa agglomerated panels

Registro completo de metadados
MetadadosDescriçãoIdioma
Autor(es): dc.creatorVillarruel, Denisse Concepción Vega-
Autor(es): dc.creatorMiranda, Eduardo Hélio de Novais-
Autor(es): dc.creatorGomes, Diogo Antonio Correa-
Autor(es): dc.creatorFurtini, Ana Carolina Corrêa-
Autor(es): dc.creatorSantos, Carolina Aparecida dos-
Autor(es): dc.creatorMendes, Lourival Marin-
Autor(es): dc.creatorGuimarães Júnior, José Benedito-
Data de aceite: dc.date.accessioned2026-02-09T11:41:44Z-
Data de disponibilização: dc.date.available2026-02-09T11:41:44Z-
Data de envio: dc.date.issued2023-06-06-
Data de envio: dc.date.issued2023-06-06-
Data de envio: dc.date.issued2022-
Fonte completa do material: dc.identifierhttps://repositorio.ufla.br/handle/1/56946-
Fonte completa do material: dc.identifierhttps://link.springer.com/article/10.1007/s10098-023-02467-6-
Fonte: dc.identifier.urihttp://educapes.capes.gov.br/handle/capes/1145394-
Descrição: dc.descriptionThe aim of this research was to evaluate the physical and mechanical properties of Pinus oocarpa wood agglomerated panels produced with the addition of wheat residue at different levels (0, 25, 50, 75 and 100%). For that, the materials were first reduced to particles and chemically characterized by density, moisture, ash content, lignin, extractives and holocellulose analysis. Resulting that the lignin and holocellulose content of the wheat particles showed lower values in relation to Pinus oocarpa wood, in contrast to the moisture, extractives and ash content, which were higher. Then, for the molding the particles were bonded using 12% urea–formaldehyde adhesive in relation to dry mass, and hot-pressed obtaining two panels from each treatment. Physically, the compact ratio and apparent density values obtained presented no significant changes in the different treatments evaluated, and the water absorption and thickness swelling evaluated after 24 h of water immersion showed a proportionally increase in these values in relation to the addition of the by-product however, did not met the minimum established in standards. Finally, the mechanical properties of modulus of rupture, and the modulus of elasticity and the internal bonding, presented a reduction of 78%, 61% and 67%, respectively, showing a decreasing trend with the increasing amount of wheat fibers, which had no strong influence over the improvement of these properties. Therefore, to verify the production feasibility of this agglomerated panels, further studies like chemical pre-treatment to the wheat particles are needed to improve their quality.-
Idioma: dc.languageen-
Publicador: dc.publisherSpringer-
Direitos: dc.rightsrestrictAccess-
???dc.source???: dc.sourceClean Technologies and Environmental Policy-
Palavras-chave: dc.subjectAgglomerated panels-
Palavras-chave: dc.subjectWheat residues-
Palavras-chave: dc.subjectPinus oocarpa-
Palavras-chave: dc.subjectUrea–formaldehyde-
Palavras-chave: dc.subjectComposite material-
Palavras-chave: dc.subjectPhysical–mechanical properties-
Título: dc.titleEvaluation of the addition of wheat residues in the production of Pinus oocarpa agglomerated panels-
Tipo de arquivo: dc.typeArtigo-
Aparece nas coleções:Repositório Institucional da Universidade Federal de Lavras (RIUFLA)

Não existem arquivos associados a este item.